#Setup tftp server serial
Make sure you have a serial connection to the target.īoot the board and hit any key to stop the autoboot and get to the U-Boot command line. $ sudo ln -fs /proc/net/pnp /home//var-fslc-yocto/rootfs/etc/nf When using NetworkManager on the target, configure NetworkManager not to manage the interface used for the NFS boot by adding the following to /home//var-fslc-yocto/rootfs/etc/NetworkManager/nf: $ sudo rename 's/zImage-//' /tftpboot/zImage-*.dtb $ for f in tmp/deploy/images/im圆ul-var-dart/*.dtb do if ] & ] then sudo cp $f /tftpboot fi done $ sudo cp tmp/deploy/images/im圆ul-var-dart/zImage /tftpboot $ sudo /etc/init.d/nfs-kernel-server restart home//var-fslc-yocto/rootfs *(rw,sync,no_root_squash,no_all_squash,no_subtree_check) and add the following line to it (replace with the actual username): build_x11/tmp/deploy/images/im圆ul-var-dart/fsl-image-gui-im圆
#Setup tftp server license key
Look at Installing License part to get information on installation of license key to your server.
#Setup tftp server install
You can get the information on license types and the purchase orders from the site You need to install the acquired license key by menu command Help->Licensing. To remove trial restrictions of your server you need to purchase license key. Check Increase server process priority and Ignore invalid requests in server settings.Set minimum level of operations logging, or switch logging off.Use Enterprise Mode license key for server work.However, you can gain additional performance using the following settings: Perhaps, it is one of the most scalable TFTP servers, represented on the market. WinAgents TFTP Server has high-performance architecture. Look at Access Rights to TFTP Folders part to get additional information. The program will display the window to set access rights for the current TFTP folder. To set access rights to TFTP server use menu command Server->Virtual TFTP Folders->Access Rights to Current Folder. You can restrict access to WinAgents TFTP Server depending on the client's IP-address and the name of TFTP virtual folder. TFTP Server Settings Configure Server Security L use UDP 69 port not only to receive TFTP requests, but also for files transmission. To activate this option, open the window TFTP Server Settings and check Enable firewall support on General tab.Īfter the window is closed, TFTP server wil It is the standard port number for TFTP requests. However, this is not common for most of routers and firewalls.Īt the same time, WinAgents TFTP Server allows using UDP 69 port for files transmission. Cisco PIX Firewall) can identify TFTP sessions in data flood and dynamically change the table of addresses translation, allowing TFTP traffic through. Therefore, even if you configured your firewall to redirect all UDP traffic with the port number equal to 69 to the TFTP server, NAT-device still will not allow TFTP sessions through.Ī number of devices (e.g. TFTP protocol supposes using random UDP ports to transfer files contents (Look at TFTP protocol part to get more additional information). WinAgents TFTP Server supports transmission of files via TFTP protocol through routers and firewalls, where NAT (Network Address Translation) mode is enabled. WinAgents TFTP Server Configure Server to Work through Firewall or NAT